Learning The “Secrets” of Moulding

Your Ultimate Guide to Crown Molding and Pot Light Installation Crown molding can be challenging because walls are not always flat and nailing can be difficult. How to attain a nice looking crown molding? In this article, we will be focusing on a project combining standard crown molding with two-pieces of mold base trim. In order to save you the trouble of needing to scarf pieces together, it is helpful measuring the length of each wall before purchasing the things you will need for your crown molding project. If you are planning to use a light-colored stain choose pieces of similar tone. For faster and better results, it is best to use a miter saw and brad nailer. If you want a rich and larger look od your crown molding, you can combine it with other types of trim like those with contrasting woods to achieve a two-tone effect. Built-up crown offers a lot of benefits such as eliminating nailing frustrations. You need to chalk lines in order to have the right position for the rail trim, marking at ceiling joists and studs so you will know where to drive the nails, and most carpenters draw lines and marks on the walls and ceiling, then just hide them with paint. An easier method is sticking bands of 2 inches wide masking tape to the ceiling and walls. You need to wait for a couple of weeks if you plan to paint the ceiling or walls before applying the tape. Install the trim over the tape, leaving the tape in place for wall and ceiling protection when finish or paint the trim. When it comes to the actual trim placement, add the piece to the right next to the first piece in place, and work around the room in that direction, so in that way, you will make most of your 45-degree cuts using a miter saw. By doing so, your molding job becomes easier, and you can also use construction adhesive on the rail (even those areas where you can nail into ceiling joists and studs) for you to use just enough nails, holding the trim into its place until the adhesive sets, with fewer nail holes to fill. Remember that you need to miter your ceiling rails both exterior and interior corners, and test the pieces to determine the exact angle. When coping wall rails, it is like coping the crown but you need to stand the trim against the saw’s fence when you’re making the 45-degree miter, and install the outside corners the last to avoid coping both ends. When it comes to crown molding and pot installation, DIY can save you labor cost but hiring a professional can save you so much time and energy. Visit our website and check the best crown molding and pot installation companies today!The 10 Best Resources For Moulding

The 10 Rules of Resources And How Learn More